High-Pressure crack injection mechanical packer 4-inch x 1/2in hole
Used with high-pressure injection pumps or modified grease guns. 50Lot
Standard Zerk fitting, with a low-pressure ball.
Common with any Polyurethane Foam products. microphone on
Ideal for high-pressure injection pumps or when minimal product leakage is specified.
Designed for the tip check ball to open up at a low pressure of 250 psi so they will function with hand injection tools without any interference.
Installation of packers
1. using a standard hammer drill, drill 1/2 inch hole diagonally every 6 inches to intersect the crack inside the wall.
2. Clean out the drilled injection, this is an important step To prevent dust inside the drilled hole from interfering with the injection.
3. Start the high-pressure crack injection process.
When other methods have failed or proved ineffective, our high-pressure packers and crack injection systems are the solution you need. The benefits of our high-pressure injection system are numerous. Not only does it effectively fast results, but it also allows for greater control with its ability to keep problem-leaking cracks under control. And with the majority of experts recommending polyurethane foam or epoxy injection for crack repair, our packer proves to be the best choice for quality results.
Sold in lots of 50
Category List
