20 Min Fast Epoxy Port Surface seal

Fast Epoxy Paste for contractors' surface sealing ports/cracks before low-pressure injection.

Dual cartridge 20-minute cure time

Nextstar 900 1:1 is a high-modulus epoxy gel designed to seal cracks and surface ports onto concrete prior to injection. It can also be used for bonding miscellaneous materials to concrete where a fast cure is required. 900 1: 1 is moisture insensitive and will cure in damp environments.
15 to 20-minute cure.

Supplied in dual cartridge tubes
A) Mixed by hand on cardboard and applied directly
B) Setting low-pressure surface ports
C) Surface sealing, one cartridge will cover approximately 10ft of crack and ports

AREAS OF APPLICATION

Ideal for foundation contractors that desire to complete the injection on one visit or are restricted, this Nextstar 900 will save travel time and costs. 
As with any epoxy adhesive, surface preparation is critical. Concrete surfaces should be cleaned by grinding, wire brushing, or other mechanical means. All loose or unsound material must be removed. Surfaces should be dry and dust-free to ensure a superior bond. Nextstar 900 1:1 will cure in the presence of moisture, although application onto wet surfaces is not recommended.

CLEAN UP
Use M.E.K. or Xylene. Clean equipment immediately after use.

SAFETY PRECAUTIONS
This product may cause skin irritation. Always wear protective clothing. Wash the contaminated area with soap and water first. Solvents may damage other surfaces, so proceed with caution. In case of eye contact, flush with water for 15 minutes; immediately see a physician.