10 Minute Mender (2 Quart) Floor Kit

Slab repair product: 10 Minute concrete mender (Roadware)

Easy to use for concrete crack and spall repair when fast high-strength repairs are needed. The product can be mixed with up to 3 parts of silica sand. This kit can provide up to 1.5gal in volume when mixed with silica sand or sandblasting sand.

10 Minute Mender Kit Contents

• 2 Quarts of 10-minute concrete mender Sample Kit
• 2 Mixing Cups
• Safety gloves and goggles
• Squeeze bottle
• Flash Drive w/ Videos and instructions
  

Ultra-thin product that penetrates deep into the concrete.
A Professional use product.
Roadware 10 Minute Concrete Mender, the advanced concrete repair material that is easy to apply and stays in place.
Now you can repair cracks and spalls to a smooth finish in a fraction of the time it takes with ordinary products. Roadware 10 Minute Concrete Mender is a revolutionary new two-part hybrid urethane for repairing concrete. It's nearly water thin for deep penetration and it won't pop out like epoxy because it never gets brittle. Not recommended for the inside of an occupied residential structure without proper ventilation for occupied basements we recommend E555. 10 Minute Mender may yellow if exposed to direct sunlight, coating over is recommended if the yellowing is a factor.
Bulk Instructions   Kit Instructions

  Core Sample under UV Light
showing deep penetration into the concrete

•  Permanent repair - doesn't pop out
•  Cures in ten minutes for traffic or coating
•  Quick and easy surface preparation - no saw cuts necessary
•  No minimum or maximum depth restrictions
•  Low installed cost vs. alternatives
•  Cures in temperatures down to -20° F
•  Bonds to concrete, masonry, steel & wood
•  Compatible with all floor coatings
•  Moisture tolerant
•  No shrinkage - 6% elongation
•  Excellent chemical resistance
•  Extremely thin - low surface tension
•  Cure stops at 4500 psi
•  Dynamic load transfer
•  May be used as a coating
•  Can be painted - Grinds well
•  Trowelable when mixed with up to 3 parts sand
•  Meets USDA guidelines
• Compatible use with Carbon Fiber Stitches and Staples